How To Use The Lawn Mower Correctly

Lawn mowers, also known as weeders and lawnmowers, are commonly used equipment for garden maintenance, and it is necessary to master the correct method of use. Check before starting, such as whether there are holes in the fuel tank and oil leakage, whether there are people in the dangerous area, etc., and then wear safety helmets, goggles, and other labor protection products correctly. When working, choose the appropriate route and speed according to the terrain and grass density, and observe the road conditions in time. When using a lawnmower to mow the lawn, pay attention to wearing sturdy shoes and disinfecting the blades and chassis after mowing. Let's look at the detailed knowledge introduction.

Things to check before starting the weeder

1. Check the fuel tank for leaks.

2. It must be replaced with a sharp blade instead of an abnormal blade.

3. Make sure that other people are not in a dangerous area before starting the engine.

4. When starting the engine, you need to hold the operating lever tightly to avoid losing control due to vibration.

5. Make sure the blade is away from the ground and not in contact with other objects before starting.

6. Be sure to use the spare parts provided by the original manufacturer, especially the blade.

7. Check whether the full cover is locked.

walk-behind lawn mowers job process

The operation of small lawnmowers is relatively simple. First of all, the choice of working path is more flexible, because the turning radius of the machine is small, and there is no flexible movement. Because the turning radius of the machine is small, there is no dead angle for walking. The density selection gear. When the ground is uneven and the pasture density is high, select a low gear, otherwise, select a higher gear. During the operation, the two clutch tensioner handles are always in the combined position, because during the operation, the engine is running at high speed, and the engagement or separation of the tensioner handles at this time is easy to damage the machine. Therefore, the operator does not need to move the two handles during the mowing process, and the operation process is relatively simple. The driver only needs to hold the handle to control the walking route of the mower.

During the operation, one should carefully observe the terrain ahead of the operation at any time. If encountering a large pit or high hill, one should slow down and make a detour, otherwise, the high-speed cutting knife will kick up a lot of dust, which is not good for the operator and the machine. This machine is only suitable for slope operations with a slope below 25 degrees. When the slope is too large, the lubricating oil cannot lubricate all moving parts, and long-term operation will damage the engine. When the machine is working, unrelated personnel should be kept away from the mower to prevent the small stones rolled up by the cutter from hurting others.

After the work is completed, disconnect the two clutch handles, then reduce the accelerator, put it in neutral, stop walking, turn off the accelerator, turn off the engine, move the cutter pinch pulley to the walking position, and start the engine again. Down, the lawn mower can walk home.